Local Reviews
for Groveport, OH
Powered by Nearby Now
Shane C.
I found the inducer motor assembly and the blower motor capacitor both needed replaced. I informed the customer and went over repair and replacement options. Customer has opted to install new furnace. System is not operational upon departure.
Jacob M.
Upon inspection, I found the unit was operating normally and there was nothing wrong. I talked with the customer and explained what they saw was normal operation for a furnace. I provided a quote for a new system upon request of the customer. System is operational upon departure.
Shane C.
I performed a combustion test during the diagnostic tests and the furnace failed. I shut the system off and informed the customer the unit was unsafe to operate. I provided a quote for a new system and will wait to hear from the customer.
Robby D.
I installed a Carrier 80% 45,000 BTU Gas Furnace. I cycled the system multiple times to ensure functionality. System is operational upon departure.
Shane C.
I found the furnace cutting out and not providing heat. I checked over the entire furnace looking for the issue. I did not find any major issues. I did find the condensate trap clogged, cleared it. I cycled the system for 20 minutes and had no issues. System is operational upon departure.
Jacob M.
I found the flame sensor to be having issues. I pulled it, cleaned it, and reinstalled it. System is now functioning properly. I also found the ignitor had a hotspot on it which could cause it to fail at any moment. I made the customer aware. System is operational upon departure.
Jacob M.
I replaced OEM Burner Assembly, all four burners. 2000 Carrier gas system is heating/operational at this time.
Jacob M.
I replaced OEM Burner Assembly, all four burners. 2000 Carrier gas system is heating/operational at this time.
Jacob M.
Performed a tune up on a 2000 Carrier gas furnace. Found that corrosion on burner bridge is causing gas to puff slightly at initial light. Ordering OEM burner assembly to replace for customer.
Jacob M.
I replaced main control board with retrofitted control board on a Trane gas furnace. I showed the home owner the back on the control board to confirm diagnostic. I cleaned the flame sensor. Cycled and monitored system. Operating normally at this time.
