Lewis Center Heating & Air Reviews in Sunbury, OH
Local Reviews
for Sunbury, OH
Powered by Nearby Now
Christopher M.
I found that the Armstrong air conditioner was low on refrigerant and the cool speed was set wrong. I added refrigerant and switched the cool speed setting. I cycled the system and unit is cooling and operating properly at this time.
Aaron B.
I completed a diagnostic on a Goodman gas furnace. Determined that the ignitor was cracked and that the control board was bad. I gave the client an estimate for repairs. I also gave the client an estimate to replace the furnace. I recommend that due to the age, condition and cost of repairs (seen and unseen) that the unit be replaced. Client declined any repairs at this time. Client will check with insurance company before proceeding.
Brandon M.
Return Service for a Trane gas furnace. Determined that the thermostat needed adjusted and reprogrammed. Reset unit. Cycled and monitored the system. Operating normally at this time.
Aaron B.
I installed an Aprilaire 600M Humidifier on a Trane gas furnace. Cycled and monitored the systems. Both operating normally at this time.
Tara L.
I performed a tune up on a Carrier gas furnace. Everything checked out within specs. System is operational upon departure.
Ian W.
I completed a tune up on a Trane gas furnace. I visually inspected the unit. I cleaned the flame sensor. Checked voltages, amps and pressures. Completed combustion analysis. Cycled and monitored system. Operating normally at this time.
Ian W.
Add a supply duct to a room in the basement.
Ian W.
I am Performing our Five Star Tune-Up & Safety Check on a 2020 Carrier Gas Furnace. All readings were within manufacturer's specifications, unit operating properly at this time.
Ian W.
I am Performing our Five Star Tune-Up & Safety Check on a 2010 Trane Propane Furnace. All readings were within manufacturer's specifications, unit operating properly at this time.
Ian W.
Found the 2014 Lennox system coding roll out safety tripped. Jumped out safety and system still would code open safety. Pulled board and found several burnt contacts. Found corrosion and hot spots on heat exchanger. Quoted new system and set install date.
